Dana 60 Ring And Pinion Installation Instructions

Ring and pinion gears are designed to be set up and run with exact tolerances.

Dana 60 ring and pinion installation instructions.

Install ring gear bolts with a six point socket and torque. We have personally experienced good results using the techniques in these instructions while setting up over forty thousand differentials. Eaton performance ring pinion installation instructions. This often requires driving in and removing the race more than once.

Pinion depth checker kits proform http amzn to 2a. On this episode i go over how to install ring and pinion gears in a ford 8 8 rear end. You must use red loctite or equivalent thread locker on the threads of these bolts. See illustrations a and b.

Knock the pinion gear out to the rear with a brass punch taking care not to damage the threads. Dana 44 and 60 rear axle housings establish pinion depth by placing a shim underneath the large inner pinion bearing race. Dana 60 110 85 ford 8 70 50 60 ford 8 8 70 70 85 ford super 8 8 irs 97 102 76 89 ford 9 70 120 80 90 gm 8 4 65 60 gm 8 6 60 65 gm 12 bolt 8 875 45 60 65 fastener choice affects the amount of torque that can be applied. Pinion depth the distance from the face of the pinion gear to the centerline of the ring gear.

Torque specs for the dana 60 are 120 ft lbs. Hope you dig it. 5 once the pinion depth is achieved install a new crush collar preload shim pack for dana s and seal. This is adjusted by adding or subtracting shims to the inner pinion bearing.

If you re changing the ring and pinion or the pinion bearings remove the pinion nut with an air gun while holding the yoke or use a long breaker bar and brace the yoke bolt it to a long board so that it can t move. 6 with the pinion gear installed position ring. Gleason gear design manuals dana spicer instruction manuals technical bulletins and general motors repair manuals. The job being done.

Ring gear and pinion tooth pattern interpretation. During the ring pinion installation there are four pr imary adjustments that will need to be made. Then loctite the pinion nut and tighten to 15 inch pounds rotating torque with used bearings or 25 inch pounds with new bearings.