It s practically impossible to feed the tile by hand into this saw in a straight line so even if the tiny electric motor didn t stall the cut would be ragged.
Cut long straight line on porcelain tile floor straight edge.
The rotary tool is ideal for cutting out curved sections of tile.
The diamond blade is very unforgiving of side loads and will bind unless the cut is very straight.
This can be attempted by a do it yourselfer although the results aren t guaranteed.
Rotate the tile to the opposite side of the initial cut which is the opposite end of the mark or scored line.
Use a straight edge to mark the line with an erasable marker.
Drive the cutting bit into the surface of the tile away from the mark and slowly move the tool along the marked lines.
3 cutting a porcelain tile.
Cut out the shape with a rotary tool using a cutting bit with a guide.
Ceramic tile is a beautiful durable surface that can last for a very long time.
The process for cutting semicircles from the edge of tiles is similar to the technique shown for full circles.
Then rather than deepen the scoring cut simply remove the excess tile with straight cuts photo 1.
The outer edge of the hole saw will cut around the bit producing a larger hole in the tile suitable for pipes to pass through.
Set the guide to the thickness of the tile.
This instructable explains how to set up guides for perfect cuts.
To cut a ceramic tile using a glass cutter start by using a pencil and a square or a ruler shaped like a right angle to measure and mark your tile.
You start by marking the cut and scoring the face of the tile on the line.
If the tile is 12 inches square cut in approximately 2 inches from the edge.
Next place the square right next to the marked line so you can use it as a guide then press down on the tile with the glass cutter and drag it along the line.
However in reality porcelain tiles are a type of ceramic tiles which are mostly used for flooring and walling purposes with an absorption rate of around 0 5.
Firmly press the edge of the glass cutter or carbide pencil along the line using a carpenter square as a guide.
Allow the guiding bit to drill straight down into the tile.